The mains plug is used to disconnect the device.To fully disconnect the device from the mains, pull out the plug. The device is connected to the mains with the power plug.Plug the mains cable into the socket (230V ~, 50 Hz Sonoclock 490, 230V ~, 50/60 Hz Sonoclock 490 Q). If this is not the case, contact your specialist dealer. Shows the frequency of the selected radio station on the frequency scale.Ĭheck that the mains voltage on the type plate (on the bottom of the device) corresponds to your local mains supply. Indicates that the alarm setting is activated with alarm time 2.ĭisplays the time, the alarm time and the sleep timer time. Indicates that the alarm setting is activated with alarm time 1. Sliding switch, switches between alarm time 1 or 2 activates alarm time 1 or 2 or 1+2.īattery compartment for 9V back-up battery. Sliding switch, switches the display between two brightness levels. Sliding switch, switches the alarm between a signal and radio and cancels the alarm. Switches the radio to stand-by mode cancelling the alarm for the day switching off the sleep timer. Switches the radio on from stand-by mode. To display the current sleep timer setting. To set the clock and alarm time with the time running slowly backwards.Īctivates the sleep timer. To set the clock and alarm time with the time running quickly forwards. Press briefly: to display the alarm time. Press and hold down: to set the alarm time. The type plate is located on the bottom of the device.No warranty claims are accepted for damage caused by incorrect handling. Do not expose the back-up battery to extreme heat, caused for example by direct sunlight, heaters or fire.Clean the device with a clean, moist leather cloth. Do not use any cleaning agent, as this may damage the casing.These additives can corrode the device supports, leaving residues on the furniture surfaces which can be difficult or impossible to remove. When deciding where to place the device, please note that furniture surfaces are covered by various types of varnish and plastic, most of which contain chemical additives.Do not cover the ventilation slots with newspapers, table cloths, curtains, etc. Make sure the device is adequately ventilated.Do not place any naked flames such as candles on the device.These may be knocked over and spill fluid on the electrical components, thus presenting a safety risk. Do not place any vessels such as vases on the device. Protect the device from moisture (water drops or splashes).This device is designed for the playback of audio signals.
0 Comments
Leave a Reply. |